Sony PCS-1/1P - Manual (Page 136)

136
Displaying the Picture on a Projector or Monitor
Displaying the Picture on a Projector or
Monitor
When you connect the Data Solution Box to the Communication Terminal,
connections with external monitors, etc. using the following four outputs are
available. The connections allow output of the picture to one or two monitors
selected from among four.
This setting is available when “Dual Monitor” is set to “Off” in the General
Setup menu. Select the output using “Monitor Out” setting in the General
Setup menu.
VIDEO OUT: Outputs the signal to a monitor (Monitor A in the illustration
above) connected to the VIDEO OUT MONITOR MAIN connector on the
Communication Terminal.
RGB OUT: Outputs the signal to a monitor (Monitor C in the illustration
above) connected to the RGB OUT connector on the Communication
Terminal.
Outputting the Signal to One Monitor
ON LINE POWER LAN ALERT
to VIDEO OUT
MONITOR
SUB
Monitor A
to RGB OUT
to VIDEO OUT
MONITOR
MAIN
Monitor D
Monitor B
Monitor C
to RGB OUT on the
PCS-DSB1