Star Micronics LC-8521 User Manual
Page 80
72 Troubleshooting
❏
While holding down the control panel’s
PARK/SET/EJECT
and
ON
LINE
buttons, turn the printer back on to enter the Dot Adjustment Mode.
The printer will print something like the following.
Note that the printer will feed the paper forward and back each time during
this operation so you can view the printout.
❏
If the two lines do not align properly, use
FONT
to move the lower line to
the left or
PITCH
to move it to the right.
The above step performs alignment for Normal-density mode only. You
must make separate adjustments for the HS-DRAFT, CRT graphics mode I,
DRAFT Text, DRAFT Graphics, Double-density, CRT graphics mode II,
Triple-density, Quadruple-density, LQ Text and LQ Graphics modes as
well.
❏
Press
PARK/SET/EJECT
to change to another printing mode.
❏
Repeat the above steps for each printing mode, if necessary.
❏
After making changes to the adjustments, press
ON LINE
to exit the Dot
Adjustment Mode and register your adjustments.
***
DOT ADJUSTMENT SETTING
***
Normal-density
0: