Star Micronics LC-8521 - Manual (Page 109)

101
Select uni-directional printing Both ESC U1
Control character height, width, line spacing IBM ESC [@
Set initial condition IBM ESC [K
Select 1 x 1, 2 x 2, 4 x 4 sized printing STD ESC h n
Stop printing IBM ESC j
Select type face STD ESC k n
Cancel double-high mode STD ESC w0
Select double-high mode STD ESC w1
NEC Commands
Description Mode ASCII Code
Set line spacing to n/360
″
STD FS 3 n
Initialize printer STD FS @
Select typeface STD FS C
Cancel expanded printing STD FS E0
Select expanded printing STD FS E1
Select expanded (triple-width) printing STD FS E2
Select forward feed STD FS F
Select standard character table STD FS I0
Select IBM character table STD FS I1
Move download characters in 00H-7FH area to 80H-FFH STD FS I2
Select reverse feed STD FS R
Cancel double-height mode STD FS V0
Select double-height mode STD FS V1
24-pin hex density bit image STD FS Z
Print characters from all character chart STD FS \
Print one character from all character chart STD FS ^
Other Commands (Continued)
Description Mode ASCII Code