Star Micronics LC-8521 - Manual (Page 77)

Installing the push tractor unit 69
Installing the push tractor unit
❏
Make sure that the printer is unplugged from its AC power source.
❏
Open the cover where you want to install the push tractor unit.
If you want to install the push tractor unit in the back of the printer, open the
back cover. If you want to install it in the front of the printer, open the
document table.
In either case, opening the cover as far as it will go will cause it to lock in place.
❏
Pressing down on the two releases on the left and right of the tractor feeder,
carefully lower it into the printer, making sure that the proper parts of the
tractor feeder fit into the slots provided in the printer as shown in the
illustration below.
❏
Close the cover of the printer.
[Back of the printer]
[Front of the printer]