Siemens 5890 User Manual

Page 26

SIEMENS 5890 DSL Router
User’s Guide

Chapter 3 Easy Setup

Select Protocol

SIEMENS

Point-to-Point Protocol over ATM (LLC Encapsulation)

If you selected Point-to-Point Protocol over ATM (LLC Encapsulation) from the Wan Interface page, the
Point-to-Point Protocol page is displayed when you click Next.

To configure Point-to-Point Protocol:

1. Enter PPP User Name and Password to use for authentication when establishing a WAN connection using

PPP protocol.

2. Select one or more of the following PPP Networking options:

•

Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select Only bridge PPPoE traffic. If selected, only PPPoE traffic is bridged; all other traffic is
stopped.

3. IP Routing Enabled:

Route all IP traffic to remote hosts.

4. If you enabled IP routing, select one of the following methods for configuring IP routing:

•

Obtain configuration automatically from WAN
IP routing parameters are obtained from the WAN.

•

Configure IP Routing manually
IP routing parameters are set manually. If you select this options, you must the Source WAN IP
Address, Subnet Mask, and Default Gateway.