Samsung ML-331X - Manual (Page 151)

Wireless network setup
48 2. Using a network-connected machine
Before entering the IP address for the machine, you must
know the computer’s network configuration information. If
the computer’s network configuration is set to DHCP, the
wireless network setting should also be DHCP. Likewise, if
the computer’s network configuration is set to Static, the
wireless network setting should also be Static.
If your computer is set to DHCP and you want to use Static
wireless network setting, you must contact the network
administrator to get the static IP address.
• For the DHCP method
If the IP address assignment method is DHCP, check if
DHCP is shown in the Wireless Network Setting Confirm
window. If it shows Static, click Change TCP/IP to change
the assignment method to Receive IP address
automatically (DHCP).
• For the Static method
If the IP address assignment method is Static, check if
Static is shown in the Wireless Network Setting Confirm
window. If it shows DHCP, click Change TCP/IP to enter
the IP address and other network configuration values for
the machine.
For example:
If the computer’s network information is as shown follows:
- IP address: 169.254.133.42
- Subnet Mask: 255.255.0.0
Then, the machine’s network information should be as
below:
- IP address: 169.254.133.43
- Subnet Mask: 255.255.0.0 (Use the computer’s subnet
mask.)
- Gateway: 169.254.133.1
16 The wireless network connects according to the network
configuration.
17 When the wireless network setting is completed, disconnect
the USB cable between the computer and machine.
18 Follow the instructions on the screen to complete the
installation. After the installation is finished, click Quit or
Restart.
19
Using a network cable
Your machine is a network compatible machine. To enable your
machine to work with your network, you will need to perform some
configuration procedures.