Sharp ER-A520 - Manual (Page 163)

161
Setting the time range for hourly reports
You can set the time range for the hourly report.
*A: Time range
To set the time range to 30 minutes (in the 24-hour system), enter 0.
To set the time range to 60 minutes (in the 24-hour system), enter 1.
BC: Starting time (hour = 00 to 23)
Setting the time range to 60 minutes with the starting time being set at 7:00
To change this setting, an hourly Z report (#160) must be taken prior to the changes.
Programming of power save mode
* Item: Selection: Entry:
A Entering power save mode when time is Enable 0
displayed. Disable 1
BCD Time (min.) to entering power save mode 1 through 254 (min.)
since no operation is made. (999: The power save mode is inhibited.)
2689 . @
0030 a
Print Key operation
Example
2689
. @ @ a
A B C D *
Procedure
2689 PGM 2
Note
2619 . @
107 a
Print Key operation
Example
Procedure
2619 PGM 2
2619
. @ @ a
A B C *
When A thru C are all zeros.