Sharp ER-A520 - Manual (Page 118)

116
Functional programming 2
(Dynamic UPC file)
For each PLU/UPC
For a range of PLUs
For a range of PLUs: PLU codes must have already been defined. If not, an error message "NO
RECORD" will appear on the display.
* Item: Selection: Entry:
A Sign (+/-) Plus 0
Minus 1
B Food stamp status Ineligible 0
Eligible 1
C Tax 4 status Non-taxable 0
Taxable 1
D Tax 3 status Non-taxable 0
Taxable 1
E Tax 2 status Non-taxable 0
Taxable 1
F Tax 1 status Non-taxable 0
Taxable 1
Tax status (taxable 1 thru 4/non-taxable)
Tax 4 is prohibited if you use the food stamp function.
A PLU/UPC not programmed for Tax 1 thru Tax 4 statuses is registered depending on the tax
status of the department which the PLU/UPC belongs to.
Note
Note
2232
. @
@ @ t Ç
End PLU code
(max. 5 digits)
*ABCDEF
To apply the current
setting of start PLU code
to PLUs within the range
Start PLU code
(max. 5 digits)
Procedure
2061 Direct 2232 2211 PGM 2
2211
2061
. @ @ t Ç
PLU code
(max. 5 digits)
* A B C D E F
To program any PLU/UPC
To program zero
To program for the following PLU/UPC
Ä
UPC code
(6 to 13 digits)