Standard Horizon MATRIX GX3000S - Manual (Page 82)

GX3000S Page 82
14.5.1 Changing GPS Information to Vessel position or COG
Allows customizing the NAV data showing GPS Information. Factory default is
“Your Vessel’s Current Position,” however, following the steps below the GPS
Information can be changed to “Course Over Ground (COG).”
1. Press and hold down the [CALL(MENU)] key until “ RADIO
SETUP ” menu appears.
2. Press the [ENT] key, then select “ NAV DISPLAY ” with the
[ ]/[ ] key.
3. Press the [CALL(SET)MENU] key.
4. Press the [
] or [ ] key to select “ Pos (Your Vessel’s Cur-
rent Position)” or “ Cru (Course Over Ground).”
5. Press the [ENT] key to store the data entered, then press
the [16/9] key to exit this menu and return to radio operation
mode.
14.5.2 External Speaker AF Selection
The AF SELECT menu allows you to set the audio output level of the VH-310’s
External Speaker to “fixed” regardress the VOL level setting of the VH-310,
which is useful to the case when use with the amplified speaker, such as the
Standard Horizon MLS-310.
1. Press and hold down the [CALL(MENU)] key until “ Radio
Setup ” menu appears.
2. Press the [ENT] key, then select “ AF SELECT ” with the [ ]/
[ ] key.
3. Press the [ENT] key.
4. Press the [
] or [ ] key to select “ Pr ” (External Speaker
Level is “Fixed”) or “ Po ” (External Speaker Level is “Adjust-
able”).
5. Press the [ENT] key to store the data entered, then press
the [16/9] key to exit this menu and return to radio operation
mode.