Standard Horizon MATRIX GX3000S - Manual (Page 63)

Page 63 GX3000S
12.8 SCAN RESUME TIME
This selection is used to select the time the GX3000S waits after a transmis-
sion ends before starting scanning.
1. Press and hold down the [CALL(MENU)] key until
“ Radio Setup ” menu appears.
2. Press the [ENT] key, then select “ SCAN Resume ” in
the “ Radio Setup ” menu with the CHANNEL selec-
tor knob.
3. Press the [ENT] key.
4. Turn the CHANNEL selector knob to select the de-
sired resume time. The resume time can be set to
“
1sec ,” “ 2sec ,” “ 3sec ,” or “ Off .” In the “ Off ” selec-
tion, the scanner will resume after the other station
stops transmitting (carrier drops).
5. Press the [ENT] key to store the selected setting.
6. To exit this menu and return to radio operation mode press the [16/9] key.
12.9 KEY BEEP (ON/OFF)
This selection allows the key beep to be turned off.
1. Press and hold down the [CALL(MENU)] key until
“ Radio Setup ” menu appears.
2. Press the [ENT] key, then select “ Key Beep ” in the
“ Radio Setup ” menu with the CHANNEL selector
knob.
3. Press the [ENT] key.
4. Turn the CHANNEL selector knob to select “
On ” or
“ Off .”
5. Press the [ENT] key to set the key beep condition.
6. To exit this menu and return to radio operation mode
press the [16/9] key.
NOTE
Emergency alarm and beeps for DSC operation cannot be turned OFF.