Standard Horizon MATRIX GX3000S - Manual (Page 40)

GX3000S Page 40
11.4.1 Transmitting an All Ships Call
1. Press the [CALL(MENU)] key. The “DSC Operation”
menu will appear.
2. Turn the CHANNEL selector knob to select “All Ships.”
3. Press the [ENT] key. (To cancel, turn the CHANNEL
selector knob to select “Exit.”)
4. Turn the CHANNEL selector knob to select the call
(“Ugency” or “Safety”).
5. Press the [ENT] key to transmit the selected type of
all ships DSC call.
6. After the ALL SHIPS CALL is transmitted, the trans-
ceiver will switch to CH16.
7. Listen to the channel to make sure it is not busy, then
key the microphone and say PAN PAN PAN or
“Securite, Securite, Securite” depending on the pri-
ority of the call. Say your call sign and announce the
channel you wish to switch to for communications.
11.4.2 Receiving an All Ships Call
1. When an all ships call is received, an emergency
alarm sounds.
The radio will automatically change to channel 16.
2. Press any key to stop the alarm.
3. Turn the CHANNEL selector knob to see the MMSI
of the vessel transmitting the All Ships Call.
4. Monitor channel 16 or traffic channel until the UR-
GENCY voice communication is completed.