Sony CMT-CP505MD - Manual (Page 57)

57 GB
Troubleshooting
CMT-CP505MD 4-241-515-11(1) GB
Optional components
There is no sound.
• Refer to General item “There is no sound.” on
page 55 and check the condition of the system.
• Connect the component properly (see page 53)
while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
• Press FUNCTION repeatedly to select
“OPTICAL IN” or “ANALOG IN”.
The sound is distorted.
• Set the volume of the connected component
lower.
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (see page 41).
• Connect the antenna properly (see page 7).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend
you connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend
it fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical
equipments.
A stereo FM program cannot be received in
stereo.
• Press FM MODE until “STEREO” appears in the
display.
Cyclical static noise is heard while recording on
an MD.
• Adjust the antenna orientation and position until
the noise stops.
If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1 Disconnect the mains lead.
2 Reconnect the mains lead.
3 Press ?/1 to turn on the system.
4 Press x (for TAPE), ENTER/START and
?/1.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared and must
be set again.