Sanyo DSR-HB8000 - Manual (Page 10)

- 9 -
T
(A)
(D)
( ✱) ( ✱)
( ✱) ( ✱)
(B)
(C)
(A) Through output of the camera video
(B) Vertical image instability may occur when switching
the camera connected to the MON2 terminal. This is
not a defect.
(C) Amplifier
*) Accessories
■ Once all the connections are completed...
1
Make sure the standby switch (D) is off and plug the
power cord in.
2 Turn the standby switch (D) on.
We recommend the use of the APC UPS (uninterruptible
power supply) as power supply. In the event of a power
failure the UPS allows for continued operation of the
systems.
• Maximum output current: 500 VA/300 W
Do not connect the power cord until all other connections have been completed.
Basic connections
GB
L8HBR_WA(DSR-HB8000_install).book 9 ページ ２００７年４月５日 木曜日 午後７時１３分