Sundance Spas CAMDEN 780 - Manual (Page 5)

Page 1
780 SERIES
1.0 Important Spa Owner Information
Your new Sundance ® 780 Series Spa is constructed to the highest
standards and is capable of providing many years of trouble-free use.
However, because heat retentive materials are utilized to insulate
the spa for efficient operation, an uncovered acrylic spa surface and
wall fittings directly exposed to sunlight and high temperatures for an
extended period are subject to permanent damage or discoloration.
Damage caused by exposing the spa to this abuse is not covered under
warranty. We recommend that you always keep the spa full of water
when it is exposed to direct sunlight and that you keep the insulating
cover in place at all times when the spa is not in use. Read and carefully
follow the requirements for your spa’s support base found in Section 4.0
titled, “Choosing a Location” (Page 9).
We constantly strive to offer the finest spas available, therefore
modifications and enhancements may be made which affect the
specifications, illustrations and/or instructions contained herein.
2.0 FCC Notice
This equipment has been tested and found to comply with the limits for
a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
1. Rearrange or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver
3. Connect the equipment into an outlet on a circuit different from the
circuit connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for FCC compliance could void the user’s authority to
operate this equipment.