Sundance Spas CAMDEN 780 - Manual (Page 18)

Page 14
780 SERIES
6.0 Electrical Wiring Instructions
IMPORTANT NOTICE: The electrical wiring of this spa
must meet the requirements of the National Electrical
Code (NEC) and any applicable state or local codes.
The electrical circuit must be installed by a qualified
electrician and approved by a local building/electrical inspection
authority.
1. Convertible 120/240v Powered dover Models Only:
•
! dANGER:
TO dECREASE THE RISK OF SHOCK,
PROdUCT dAMAGE OR ELECTRICAL FIRE.
120v “Plug-in” Operation: This spa must operate on the
supplied 10 foot (3m) 120V GFCI cord at its original length or
must be hard-wired for longer runs. NEvER USE AN EXTENSION
CORd FOR ANY REASON!
• Convertible 120/240V Heater Operation: the included 120V GFCI
cord must be discarded for 240V heater operation. This spa must
be hard-wired. Supplying power to either configuration above
which is not in accordance with these instructions will void both
the independent testing agency listing and the manufacturer’s
warranty.
Export 2-Pump Certa/Chelsee/Hamilton Models (50 Hz)
230v/20A* 230v/30A** 230v/40A***
Voltage: 230 VAC 230 VAC 230 VAC
# of Wires: 3 3 3
Frequency: 50 Hz 50 Hz 50 Hz
Current Draw: 15A 23A 29A
Circuit Breaker: 20A* 30A** 40A***
* In 20A configuration, the heater will not operate while either jets pump is
running in high speed. This is the factory setting. Note: pump 2 runs
only in high speed.
** In 30A configuration, the heater will not operate while both jets pumps
are running in high speed. Note: pump 2 runs only in high speed.
*** In 40A configuration, the heater will operate while both jets pump are
running in high speed. Note: pump 2 runs only in high speed.