Sundance Spas CAMDEN 780 - Manual (Page 22)

Page 18
780 SERIES
7.0 Spa Fill Up Procedure
For best results, read each step in its entirety before proceeding with
that step.
1. Prepare The Spa For Filling
Clear all debris from the spa. (Although the spa shell has been •
polished at the factory, you may want to treat it with a specially
formulated spa cleaner.) Consult your dealer for additional
information prior to filling spa.
Remove filter lid (page • 24), then remove filter cartridge from filter
bucket as illustrated in Section 11.1 (pages 31-32).
2. Fill Spa
Place the end of your garden hose into the empty filter bucket. •
CAUTION: TO dECREASE bUILd UP ON COMPONENTS ANd
MINIMIZE ACRYLIC dAMAGE.
Never fill with water from a water softener. If your water is extremely
“hard”, it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
!
•
WARNING:
TO dECREASE RISK OF INFECTION OR
dISEASE.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments. Fill until water covers all jets but does
not touch the bottom of the lowest headrest. (DO NOT OVERFILL!)
IMPORTANT: Always fill your spa through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove the hose
and replace the filter cartridge as illustrated in Section 11.1 (pages
31-32).
3. Turn On Power
Turn on power to spa at the home’s circuit breaker to start boot up
sequence (Section 9.0, page 25). The heater and filter/circulation
pump will automatically activate after several seconds. If the control
panel LED flashes water temperature and “COOL” or “ICE” this is
normal. Refer to page 41 for additional information.