beautypg.com

1 ph control, 2 sanitizing, Warning – Sundance Spas CAMDEN 780 User Manual

Page 42

background image

Page 38

780 SERIES

WARNING:

FAILURE TO MAINTAIN WATER QUALITY

WILL:

Increase risk of contracting a waterborne illness (e.g. an

infection bacteria or virus) and/or respiratory ailments.

Damage the equipment, components and spa shell, which

are not covered under the hot tub’s warranty.

!

CAUTION: Never store hot tub chemicals inside the hot tub’s equip-

ment bay. The equipment bay may reach elevated temperatures,

this is where high voltage electronic devices are located. This area

is not intended for storage of any kind.

12.1 pH Control

pH is a measure of relative acidity or alkalinity of water and is measured

on a scale of 0 to 14. The midpoint of 7 is said to be neutral, above

which is alkaline and below which is acidic. In spa water, it is very

important to maintain a slightly alkaline condition of 7.4 to 7.6 pH.

Problems become proportionately severe the further outside of this

range the water gets. A low pH will be corrosive to metals in the spa

equipment. A high pH will cause minerals to deposit on the interior

surface (scaling). In addition, the ability of the sanitation agents to keep

the spa clean is severely affected as the pH moves beyond the ideal

range. That is why almost all spa water test kits contain a measure for

pH as well as sanitizer.

12.2 Sanitizing

To destroy bacteria and organic compounds in the spa water, a sanitizer

must be used regularly. Chlorine and bromine are the two most popular

sanitizers used to date. SunPurity™ mineral cartridge designed

specifically for your hot tub. Many other additives are available for your

spa. Some are necessary to compensate for out-of-balance water;

some aid in cosmetic water treatment and others simply alter the feel or

smell of the water. Your authorized Sundance dealer can advise you on

the use of these additives. When adding spa shock (chlorine or non-

chlorine) or pH balancing chemicals activate the jets pump(s) and leave

the spa cover open for a minimum of 20 minutes. By doing this you will

allow excessive chemical vapors to exit the spa, protecting pillows and

plastic knobs from chemical attack.