Sherwood R-765 - Manual (Page 35)

T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10 +10
MACRO MACRO
35
• The audio signal from the CD and the video signal
from the VIDEO 2 will be dubbed and you can
enjoy them on the TV set and from the speakers.
Note : Be sure to observe the order of the above steps
1 and 2.
Start recording on the VIDEO 1.
3
Start play on the VIDEO 2 and the CD
respectively.
4
DIGITAL AUDIO RECORDING WITH MD RECORDER
For digital recording, select the desired
digital input as recording signal input.
2
Select a desired input of CD, VIDEO 1~3
as a recording source.
1
Start recording on the component
connected to OPTICAL DIGITAL OUT.
3
• Only when the OPTICAL DIGITAL OUT of this receiver is connected to the OPTICAL DIGITAL IN of the MD recorder or CD
recorder, you can enjoy high-quality sound of digital recording without converting the original signals. Refer to “
CONNECTING AUDIO COMPONENTS”, “CONNECTING VIDEO COMPONENTS” and “CONNECTING DIGITAL INs and
OUT” on pages 6~9 and the operating instructions of the MD recorder or CD recorder.
Notes:
• Digital recording is available for the digital audio program sources such as CDs, MDs, some DVDs, etc.
• In most DVDs as well as some CDs, etc., digital recording may not be available depending on the signal format.
• There are some restrictions on recording digital signals. When making digital recordings, refer to the operating instructions of
your digital recording equipment to know what restrictions are imposed.
or
INPUT SELECTOR
VIDEO AUDIO
Start play on the desired input.
4
• Each time this button is pressed, the corresponding
input is selected as follows:
A(nalog) c(oaxial) 1 c(oaxial) 2
o(ptical) 2 o(ptical) 1
Note : When the selected digital input is not
connected, “DIGITAL” indicator flickers.
There will be no recording as well as no sound.
DIGITAL
INPUTS
CD
VIDEO 1
VIDEO 2
VIDEO 3