Sherwood R-765 - Manual (Page 30)

30
Memorizing the adjusted channel levels
Adjust the level of the selected channel
as desired.
2
Repeat the above steps 1 and 2 to adjust each channel level.
3
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the range
of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the setting
as necessary.
• If the channel display disappears, start from the step
1 again.
• ”REF. 1” is displayed and “1” flickers.
After doing the above steps 1~3 in “Adjusting the current channel level”, press the below button.
1
Select the desired space between REF. 1 and
REF. 2.
2
Press below button.
3
This unit gives two spaces(“REF.1” and “REF.2”) for memory of the adjusted channel levels. You can call the
memorized again whenever you want.
• The adjusted channel levels have now been
memorized.
or
ADJUST
T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
T/V T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
CH/LEVEL
or
ADJUST
T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
T/V T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
CH/LEVEL
T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
ENTER
MEMO/ENTER
or
T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
T/V
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10
MACRO
ENTER
MEMO/ENTER
or