Sherwood R-765 User Manual
Page 21
21
• Each time this button is pressed, the corresponding
tone mode is selected and shown for several seconds
as follows:
BASS
TRBL(treble)
TONE ON
• When the tone mode is off, “TONE OFF” is shown.
Enter the tone mode.
10
• At “TONE ON” mode, you can select “TONE OFF”
mode and vice versa.
TONE ON: When adjusting the tone for your taste.
(“DIRECT” indicator goes off.)
TONE OFF: When listening to a program source
without the tone effect.
(“DIRECT” indicator light up.)
• In general, we recommend the bass and the treble to
be set to 0(flat) level.
Notes:
• If the tone display disappears, start from the step 10
again.
• Extreme settings at high volume may damage your
speakers.
• When the digital signals from DTS or Dolby Digital
program sources are input in available surround
mode or the 7 CH DIRECT is selected as an input
source, you cannot adjust the tone and can hear a
program source without the tone effect.
At the desired tone mode, adjust the tone
as desired.
11
Adjusting the tone(bass and treble)
TONE MODE
ADJUST