Symmetricom EDGE CLOCK 1000 User Manual
Page 185
097-58001-02 Revision G – April 2008
TimeProvider User’s Guide 185
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
SIDCHG
Source ID has been changed
UIDCHG
User’s name has been changed
USRADD
User has been added
USRDEL
Specified user has been deleted, or all users have been deleted
XFERFAIL
Configuration transfer failed
XFEROK
Configuration transfer successful
GPS Codes
MODE
User has set or requested system position, or position has been automatically
found
POS
User has set or requested Lat/Lon/Ht of GPS antenna
ELEVMASK
User has set or requested the GPS Elevation Mask
IOC Codes
CCALIGN
User has cleared the INTPRR alarm, or has cleared the alarm and forced the
alignment between the CC output and a CC input
CLKTYPE
Clock type has changed
INPREF
Specified input is selected as system reference
IOCMODE
IOC mode is
IOCSTATE
IOC state has changed
RESET
Module has been reset
SYSMODE
System mode of operation has changed
IOC Clock Events
CLKFSTLK
Clock entered Fast-lock mode
CLKLOCK
Clock entered Lock mode
SCAVAIL
SmartClock algorithm
IOC Input Events
CRCENA
Input CRC has changed
FRMTYPE
Input framing type has changed
INSTATE
Input state has changed
PMCLR
Performance data has been cleared
PRIORITY
Priority has changed
Table 6-8. Conditions Causing an Event (Continued)
Event ID
Condition