Symmetricom EDGE CLOCK 1000 - Manual (Page 109)

097-58001-02 Revision G – April 2008 TimeProvider User’s Guide 109
Chapter 4 Provisioning the TimeProvider
Provisioning the Input Reference
Setting the GPS Parameters
After you install the GPS antenna, you must provision the parameters using the
ED-EQPT command.
ED-EQPT:[]::[]::=;
This command has a default access level of ADMIN.
Sample Command
ED-EQPT::GPS:TS1000::MODE=AUTO;
This command sets the GPS location mode to Automatic. The location of the GPS
antenna is determined from multiple satellite fixes.
Autonomous Message
TP-SSU 03-10-24 10:45:15
A 1179 REPT EVT
“GPS,EQPT:NA,FRMTYPE,NSA,03-10-24 10-45-15:\"GPS MODE HAS
CHANGED,AUTO\””
;
To manually set the location of the receiver, you must enter the latitude, the
longitude, and the altitude (in m) in the same command, using commas to separate
the parameters.
Sample Command
ED-EQPT::GPS:TS1000::POS=30-28-34.0N,97-50-16.0W,333.0;
Description Default value
GPS MODE AUTO The antenna position (latitude,
longitude, and elevation) is
automatically computed or
recomputed and set AUTO
MANUAL The position (latitude, longitude, and
elevation) is set manually using the
POS keyword
GPS
(cont’d) POS
Note: The
position can
only be set
when Mode
is MANUAL LAT dd-mm-ss.ssN or
dd-mm-ss.ssS n/a
LONG dd-mm-ss.ssE or
dd-mm-ss.ssW
ELEV hhhh.hh height in m
ELEVMASK 5 to 45 The elevation mask, below which the
TimeProvider will not track or acquire
a satellite 10