Sanyo PLC HF15000L - Manual (Page 73)

7
Maintenance and Care
CAUTION
• After cleaning or replacing the filter, i nsert the AMC unit
completely. If not, the projector cannot be turned on.
• Do not put anything into the air vents. Doing so may
result in malfunction of the projector.
• Do not wash the filters in water or any other liquid.
Otherwise the filters may be damaged.
• When using a vacuum cleaner to remove the dust on
the mesh filter, be careful as the filter tears easily.
• When the mesh filter gets too dirty, contact your authorized
dealer or service center.
ORDER REPLACEMENT FILTER
Replacement filter can be ordered through your dealer. When ordering, give the following
information to the dealer.
l
Model No. of your projector :
PLC-HF15000L
l
Replacement Filters (sold as a set): 610 354 6902 (service parts code)
An Electrostatic Pleated Filter
An Electrostatic Honeycomb Filter
Holder A
Holder B
Holder B
Holder A
Electrostatic
pleated filter
Electrostatic
honeycomb filter
4
6
7
8
9
Slide forward a pair of the holders: A and B, loosen the 3
screws that secure the holders, and remove the holders.
After inserting your fingers through the slits and lifting
the filters on the mesh filter to remove them easily,
remove the filters one by one, and if necessary, suck up
the dust accumulated on the mesh filter and the frame
with a vacuum cleaner.
Put the new electrostatic honeycomb filter on the
mesh filter, the new electrostatic pleated filter on
the honeycomb filter, the holders on the electrostatic
pleated filter, respectively, and then fix with the screws.
Slide backward the holders until the arrow marks on the
holders are aligned with those on the AMC unit.
Place the AMC unit back into the projector and fix it
with the 2 screws.
Plug the power cord, power on the projector and reset
the filter counter.
5
4
6
Screws
Slit
Slit
5
Replacing the Filters
Loosen the 2 screws that secure the AMC unit and
pull it out.
Remove the dust on the projector and air vents.
Press the ON/STAND-BY button on the side control
or the STAND-BY button on the remote control, flip
the Main On/Off Switch off, and then unplug the AC
power cord from the AC outlet.
1
2
3
AMC unit
3
Screws