Sanyo PLC HF15000L - Manual (Page 68)

68
✔ Note:
• Normally, the filter cleaning unit automatically starts cleaning
the mesh filter either while cooling down the projector after
the power was turned off or after restarting the projector.
• When the icon as shown in Fig.3 appeared for the first time,
replace the filters as soon as possible. If you turn off the
projector before you replace the filters, the projector will turn
off 3 minutes after the power is turned on next time.
This icon is warning you that the
remaining time has reached 0% and
the filters need to be replaced as soon
as possible.
Fig.3
✔ Note:
• Fig.1, Fig. 2, and Fig. 3 appear at turning on and selecting input
source.
• Fig.1, Fig. 2, and Fig. 3 will not appear when the Display
function is set to Off (p.54) or during “Freeze” (p.31).
This icon is warning you that the
remaining time has reached 10%.
Fig.2
This function is used to set a frequency for the filter
replacement.
Use the Point ed buttons to select Filter counter and
then press the Point 8 or the SELECT button to access the
submenu items.
Filter counter . . . . . . . . . Shows the total used filter time.
The filter counter is displayed in
red when filter counter exceeded
the time specified for Filter counter
timer, or filter clogging was
detected.
Filter counter remaining ... Shows the remaining time every
10% until the specified time
comes. (p.74). When the remaining
time reached 10%, it is displayed in
red.
Filter counter timer. . . . . To set the timing of replacing with
a new filter. The filter replacement
icon appears when filter counter
exceeded the specified time or
filter clogging was detected.
(Options available for the mesh
filter: Off/4000H/8000H/12000H/16000H,
Options available for an optional
smoke resistant filter: Off/10H/15H/
20H)
Filter counter reset . . . . . To reset the filter counter. Select
Reset, press the SELECT button,
and select Yes in the confirmation
box (p.74).
Auto cleaning timer . . . . To schedule a filter cleaning task
when the length of time you used
the filter reached the specified
time. (Options: 50H, 100H(default),
150H).
Fig.1
Press the SELECT button to select Filter counter
timer and use the Point ed buttons to set
the timer. Select from (Off/ 4000H/ 8000H/
12000H/16000H) depending on the use
environment.
Settings
Filter counter
This icon is warning you that the
remaining time has exceeded the
specified time.