Sanyo PLC HF15000L - Manual (Page 63)

6
Settings
No signal
4 : 50
Timer left before Lamp is off.
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready ................. When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the side control or remote control is
pressed.
Shut down ......... When the lamp has been fully cooled
down, the power will be turned off.
Off ..................... Power management function is off.
Timer ................. If the input signal is interrupted and
no button is pressed for more than 30
seconds, the timer display with No signal
appears. It starts the countdown until
the lamp is turned off. Use the Point ed
buttons to set the Timer(1~30Min).
When this function is set to On, the projector will be
automatically turned on just by connecting the AC power
cord to the wall outlet.
✔
Note
• Be sure to turn off the projector properly (see “Turning Off
the Projector” on page 25). If the projector is turned off in the
incorrect sequence, the "Direct on" function does not work
properly.
✔ Note
• Factory default is Ready: 5 Min.
• When the shutter is closed while the Power management
function is working, the Power management function is
released.
Power management
Direct on
Select a location of the infrared remote receiver of the
remote control. See “Remote Control Receivers and
Operating Range” on page 15 for details.
All .................... Activates all of the receivers
Front & Top ...... Activates both the front and top receivers
Top & Back ...... Activates both the top and back receivers
Front & Back .... Activates both the front and back receivers
Front ................ Activates only the front receiver.
Top ................... Activates only the top receiver
Back ................ Activates only the back receiver.
RC sensor
✔
Note
• When placing the projector in the horizontal position, as
fluorescent light may negatively affect the remote control
signals, it is recommended to select either “Back” or “Front” to
prevent the receiver on top of the projector from picking up the
signals from the remote control.