Sanyo PLC HF15000L - Manual (Page 42)

4
Clear the check mark if you do not want to apply the adjusted
color data; select the check mark and then press the SELECT
button. The check mark disappears.
LIST MODE
Return to the COLOR SELECTION mode so that you can
readjust the setting for the color in that line. (This option is
not available if the check mark is cleared.)
Select the DEL box if you want to delete the adjusted data.
Press the SELECT button and a confirmation box appears and
then select [Yes].
Delete all the data in the list. Press the SELECT button and a
confirmation box appears and then select [Yes].
The same function as stated above.
COLOR PALETTE
DEL
ALL DEL
COLOR M.
In the COLOR MANAGEMENT LIST, the adjusted color data
are checkmarked. You can decide whether or not to apply the
adjusted color data in the list to the projected image (see
below).
4
MENU
The same function as stated above.
Level and phase
adjustment palette.
Gamma
adjustment palette.
LIST COLOR M. MENU
COLOR PALETTE
DEL
ALL DEL MENU COLOR M.
COLOR SELECTION MODE
LIST MODE
Press the Point 7 button to lighten red tone; press the Point
8 button to deepen red tone (from 0 to 63).
Press the Point 7 button to lighten green tone; press the
Point 8 button to deepen green tone (from 0 to 63).
Press the Point 7 button to lighten blue tone; press the
Point 8 button to deepen blue tone (from 0 to 63).
Use the Point 7 8 buttons to select the desired Color temp.
level (XLow, Low, Mid or High).
Return to the IMAGE ADJUST Menu. Any settings that
have been changed will not be stored. To store the changed
settings, be sure to select “LIST” and go to the COLOR
MANAGEMENT LIST.
MENU
Computer Input
Color temp.
White balance (Red)
White balance (Green)
White balance (Blue)