Siemens 600 Series - Manual (Page 89)

Making Calls 3–25
3. Making
C
alls
➩ If you want to set up another R- key, press the
STORE key. If you have a display telephone,
STORED is displayed. Repeat the two previous
steps.
➩ To end setup, press the PROGRAM key. The
PROGRAM status light turns off. If you have a
display telephone, STORED is displayed.
➩ On your faceplate, use a pencil to label each
R- key you changed with the name of the
feature or person it dials.
To clear a
repdial key on a
display
telephone ➩ Press the PROGRAM key. The PROGRAM
status light turns on. PRESS FEATURE KEY
OR DIAL CODE is displayed.
➩ Press the repdial (R-) key you want to clear.
REPDIAL is displayed, followed by the dialing
sequence.
➩ Before NEW NUMBER? is displayed, press the
CLEAR key. DELETED is then displayed.
➩ To clear another R- key, press the STORE key.
STORED is displayed. Repeat the two previous
steps.
➩ To end setup, press the PROGRAM key. The
PROGRAM status light turns off.
➩ On your faceplate, erase the label next to each
R- key you have cleared.
Note
You cannot clear a repdial key on a non-display
telephone or any telephone without a Clear key,
though you can set it up to dial a different sequence.