SMC Networks SMC8013WG - Manual (Page 21)

Configuring a Predefined Filtering Access Rule:
1. On the Side Navigation bar, click on [Firewall] then select [Access Control]
2. Under the Predefined Section, click on the [Add] button
3. On the next page, select the service that you want to block from the pull-down menu
4. Select the [LAN IPs] that you want this access rule to apply to. You can choose to apply
this rule to Any IP Address, a Single IP Address, or a Range of IP Addresses.
If you choose [Any] for the LAN IPs you don’t need to configure the [Start IP] or [End IP]
options.
If you choose [Single address] enter in the LAN IP address of the PC into the [Start IP]
section.
If you choose [Address Range] enter in the starting LAN IP address in the [Start IP]
section and enter in the ending LAN IP address of the range you want in the [End IP]
section.
5. When your configuration is complete, click the [Apply] button to save your changes and
return to the main Access Control page.