SMC Networks SMC8013WG - Manual (Page 15)

CHAPTER 6 | Navigating the Web-based Administration
The EZ Connect™ Wireless Cable Modem Gateway’s management interface allows you to
configure both basic and advanced features and options. Some of these advanced functions
include: hacker attack detection, IP and MAC address filtering, intrusion detection, virtual
server setup, virtual DMZ hosts, as well as other advanced functions.
6.1 | Making Configuration Changes
Once a configuration change has been made on a page, be sure to click the [Apply] or [Next]
button at the bottom of the page to enable the new setting.
6.2 | System
This section is used to configure the device mode and administration options.
On the screen shown below, you can configure the Router Name.
6.2.1 | Password Settings
From this section you can configure a new administration password that is used to access the
web management from your local LAN or by remote management from the WAN (internet).
To access the Remote Management configuration page, on the Side Navigation bar, click on
[System] link and then click on the [Password Settings] link.
If your password is lost, or you cannot gain access to the user interface, press the Reset button
on the rear panel (holding it down for at least five seconds) to restore the factory defaults.