Setup, Inventory, Se tu p – Woodstock SHOP FOX M1113 User Manual
Page 12

-10-
Model M1113 (Mfg. Since 2/08)
SE
TU
P
Keep. machine. disconnected. from.
power.until.instructed.otherwise.
SETUP
This machine has been carefully packaged for safe trans-
portation. If you notice the machine has been damaged
during shipping, please contact your authorized Shop Fox
dealer immediately. The following is a description of the
main components shipped with the Model
M1113.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the pack-
aging materials carefully. Occasionally we pre-install cer-
tain components for safer shipping.
Main.Components:.(Figure.2).
Qty
A. Table .........................................................1
B. Table Extension ............................................1
C. Table Insert .................................................1
D. Rear Rail ....................................................1
E. L-Brackets ..................................................2
F. Front Rail ...................................................1
G. Fence Assembly ............................................1
H. Miter Gauge Holder .......................................1
I. Miter Gauge ................................................1
Fasteners,.Tools,.&.Miscellaneous:.(Figure.3).
Qty
• Hex Bolts
5
⁄
16
"-18 x 2" (Table Extension) ...............2
• Hex Nuts
5
⁄
16
"-18 (Table Extension) .....................2
• Flat Washers
5
⁄
16
" (Table Extension) ....................4
• Knobs
3
⁄
8
"-16 (Table Trunnion) ...........................2
• Cap Screws M6-1 x 16 (Rear Rail to Table) ............2
• Cap Screws M6-1 x 16 (L-Brackets to Table) ..........2
• Knobs
5
⁄
16
"-18 x
5
⁄
8
" (L-Bracket to Front Rail) ........2
• T-Slot Nuts
5
⁄
16
" (L-Bracket to Front Rail) .............2
• Scale (Front Rail) ..........................................1
• Guide Blocks (Blade Guides) .............................6
• Thumb Screws
1
⁄
4
"-20 x
1
⁄
2
" (Blade Guides) ...........6
• Hex Wrenches 3 and 5mm ........................ 1 each
• Flat Wrench 12/14mm ....................................1
Inventory
Figure.2. Main component inventory.
Figure.3. Fasteners, tools, &
miscellaneous item inventory.