Smart Technologies 4000i - Manual (Page 38)

32 Appendix A: Removing and Replacing the Projector 99-00582-20 REV A0
5. Using the TR20 torx key included in the accessory kit, loosen and remove the three bolts that
attach the projector to the projector plate. Set these bolts aside.
NOTE: Don’t change the position of any other screws, bolts or knobs.
6. Lift the projector off the mounting plate and remove it from the cabinet.
7. Carefully place the projector on a flat surface.
NOTE: If you’ve removed the projector in order to replace the lamp, see the projectiondesign
F20 user’s guide for further information.
NOTE: To install the projector, follow the above instructions in reverse order.
WARNING
Do not touch or replace the projector lamp (which will be very hot) for at least
one hour after turning off the projector.
TIP
Prior to reinstalling the projector, clean the projector’s lens and the small mirror
in the cabinet. To clean the lens, carefully wipe it with lens paper. To clean the
small mirror, spray a soft cloth with standard, alcohol-free glass cleaner and
gently wipe it clean.
Loosen these
three bolts.