Smart Technologies 4000i - Manual (Page 3)

99-00582-20 REV A0 Important Information i
Important Information
Please read this manual carefully before setting up and using the Rear Projection SMART Board™
4000i interactive whiteboard.
Other Precautions
For operating safety and to avoid damage to the cabinet and its parts, please read the following
information carefully.
• Move the unit with care. Quick stops, excessive force and movement over uneven surfaces
can overturn the unit.
• If you transport the 4000i, ship it in an upright position only, and never lay it facedown. In
addition, ensure that the projector is secure, or remove the projector from the cabinet and
package it with as much padding as is reasonably possible to protect it from vibration and
shock.
• If you transport the 4000i over a long distance, completely repackage it using the original
packaging. This packaging was designed with optimal shock and vibration protection. If the
original packaging isn’t available, pack all the components with as much padding as
reasonably possible to protect them from vibration or shock.
• Clean the interactive whiteboard surface regularly so that dust doesn’t build up on the surface
and adversely affect the operation of the 4000i.
WARNING
The projector inside the unit is a high brightness light source. Don’t look directly
into the beam of light. Prevent children from looking directly into the beam.
WARNING
To reduce the risk of fire or electric shock, don’t expose this product to rain or
moisture.
WARNING (For European customers only)
Use the 4000i with European TN and TT power distribution systems only. The
4000i isn’t suitable for older, IT-type power distribution systems found in some
European countries. “This system (IT-type) is widely used isolated from earth, in
some installations in France, with impedance to earth, at 230/400V, and in Norway,
with voltage limiter, neutral not distributed, at 230V line-to-line.” (IEC 60950:1999)
Contact qualified personnel if you’re uncertain about the type of power system
available where you’re installing the 4000i.
CAUTION The projector inside the 4000i has been designed for use under normal operating
conditions only. Normal operating conditions are defined as product use that does
not exceed eight hours per day and 260 days per year. Exceeding these operating
conditions could cause projector damage. Damage caused by such extended use
won’t be covered by the product warranty.