Sanyo VPC-HD1E - Manual (Page 38)

English
32
HINT
To immediately activate the power save function
i Press the ON/OFF button briefly to active the power save function.
About the standby mode
i To turn off the camera only briefly, you can close the monitor unit to put the
camera in the standby mode. The standby mode uses almost no power.
When the monitor unit is opened again, the camera turns on immediately
and you are ready to shoot or view images without any delay.
If the date and time setting has been completed (page 36)...
i The current time is shown on the monitor when the camera is turned on.
CAUTION
If the K icon appears...
i When a picture is taken, the date and time it was captured are recorded
with it. If the date and time settings have not been completed (page 36),
the date and time cannot be recorded with the captured images. For this
reason, immediately after the camera is turned on, the “SET DATE AND
TIME” reminder briefly appears, after which the K icon is shown on the
Shooting Screen. To have the date and time recorded with the images,
please complete this setting before capturing images.
00:02:27 00:02:27 33 33 00:02:27 33
SET DATE AND TIME