Sanyo VA-SW8000 - Manual (Page 116)

115 English
DVR Management Menu
(Required user access level: ID4)
Specify which conditions should trigger the
warning buzzer by selecting either the “ON” or
“OFF” radio button for each condition.
5 ALARM ON (default: ON)
When an alarm condition is detected.
6 DISK FULL (default: ON)
When the hard disk runs out of free space.
(This takes effect only when [OVERWRITE]
is set to “OFF”.)
7 KEY IN (default: OFF)
When a button on the DVR’s front panel is
pressed.
8 WARNING (default: ON)
When any of the following has occurred:
• Hard disk failure
• Fan failure
• Recording error
• VIDEO LOSS
9 NON REC (default: OFF)
When an ongoing recording session is
stopped.
When the DVR’s buzzer has sounded,
you can stop the buzzer by pressing
any button on the front panel.
When you have finished configuring the
settings on this tab, click
and
make sure that the tab index text turns
yellow.
When you have finished your
configuration task across all the tabs,
finally click
. Configuration
information is uploaded to the DVR, and
the tab index text returns from yellow to
black. (For more information on the
command buttons, see P103.)