Appendix, Care, Contact with liquid – Siemens Gigaset C340 User Manual
Page 34: Questions and answers, Care contact with liquid questions and answers, Lems see
33
Appendix
Gigaset C340 / Im-eng / A31008-M1621-R101-1-7619 / appendix.fm / 23.11.04
Appendix
Care
¤
Wipe the base and the handset with a
damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth as this can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your phone, you can contact us any time
The table below contains a list of
common problems and possible solutions.
!
The display is blank.
1. The handset is not switched on.
¥
Press the 'end call' key
a
and hold.
2. The battery is flat.
¥
Charge the battery or replace it
The handset does not respond to a key
press.
The keypad lock is activated.
¥
Press the hash key
#
long (page 7).
"Base x" flashes in the display.
1. The handset is outside the range of the
base.
¥
Move the handset closer to the base.
2. The handset has been de-registered.
¥
Register the handset (page 24).
3. The base is not switched on.
¥
Check the base's mains adapter
" Please Register" flashes in the display.
No base is switched on or within range.
¥
Move the handset closer to the base.
¥
Check the base's mains adapter (page 5).
Handset does not ring.
1. The ringer is switched off.
¥
Activate the ringer (page 29).
2. Call diversion is set to
All Calls
.
¥
Switch off call diversion.
You hear no ring tone/dial tone.
The base's telephone line cord has been
replaced.
¥
When buying a replacement line cord,
ensure that the line plug has the correct
type of wiring (page 6) .