Siemens Gigaset C340 - Manual (Page 30)

29
Handset settings
Gigaset C340 / Im-eng / A31008-M1621-R101-1-7619 / settings_bs_hs.fm / 23.11.04
You can also set different melodies for the
following functions:
u External Calls : For external calls
u Internal Calls : For internal calls
Setting ringer volume
The ringer volume is the same for all types
of ring.
With the handset in idle status, open the
menu Ringer Volume by pressing t
briefly.
§Menu§
¢
Audio Settings
¢
Ringer Volume
q Adjust the volume and
press §OK§ .
a Long press (idle status).
Setting ringer melody
Set different ringer melodies for external
and internal calls.
§Menu§
¢
Audio Settings
¢
Ringer Melody
Select External Calls / Internal
Calls and press §OK§ .
q Select melody ( ‰ = on) and
press §OK§ .
a Long press (idle status).
Activating/deactivating the ringer
You can turn off the ringer on your hand-
set before you take a call or while the
phone is in the idle state. The ringer can-
not be re-activated while an external call is
in progress.
Deactivating the ringer
P Press the star key and hold
until you can no longer hear
the ringer tone.
Re-activating the ringer
P Press the star key long.
Activating/deactivating the
suppression of the first ring tone
The phone identifies an incoming SMS
from the first network signal.
§Menu§
5 4 O 1 O
1
§OK§ To suppress the first ring tone.
Or:
Q
§OK§ To hear the first ring tone.
Please note:
If first ringer tone suppression is deacti-
vated, then every incoming SMS will be
signalled by a ring tone. If you take this
type of "call" at the first ring tone, you will
lose the SMS.
Activating/deactivating
advisory tones
Your handset uses ‘advisory tones’ to tell
you about different activities and statuses.
The following advisory tones can be acti-
vated and deactivated independently of
each other:
u Key beep: Each key press is acknowl-
edged.
u Acknowledge tones:
– Confirmation beep (rising tone
sequence): at the end of an entry/
setting, when the handset is placed
in the base station and on arrival of
an SMS or a new entry in the calls
list.
– Error beep (descending tone
sequence): when you make an
incorrect entry.
– Menu end tone: when scrolling at
the end of a menu.
u Battery low beep: the battery needs to
be charged.
The confirmation beep when the handset
is placed in the base cannot be deacti-
vated.