Troubleshooting, Operating power, Recording/playback – Sony PMW-F3K User Manual
Page 147: Operating power recording/playback
Troubleshooting
147
Ap
pen
dix
e
s
Troubleshooting
Operating Power
Symptoms
Cause
Remedy
The camcorder does not
power on when you set
the power switch to ON.
No battery pack is mounted and no
power is supplied to the DC IN
connector.
Mount a battery pack (page 22) or connect an AC
power using the AC-DN10 (page 23) .
The battery pack is completely
exhausted.
Replace the battery pack with a fully charged one
(page 22).
The power supply cuts
while operating.
The battery pack becomes exhausted. Replace the battery pack with a fully charged one
The battery pack becomes
exhausted very quickly.
The ambient temperature is very low. This owes to the battery characteristics and is not a
defect.
The battery pack is inadequately
charged.
Recharge the battery pack (page 22).
If the battery pack is soon exhausted even after you
charged it fully, it may comes to the end of its life.
Replace it with a new one.
Recording/Playback
Symptoms
Cause
Remedy
Recording does not start
when you press any
recording start/stop
button.
The power switch is set to OFF.
Set the power switch to ON.
The SxS memory card is write-
protected.
Release the write protection (page 34), or replace the
card with a non-protected SxS memory card.
The SxS memory card is full.
Replace the card with one having sufficient space.
The SxS memory card needs
restoration.
Restore the memory card (page 37).
Playback does not start
when you press the PLAY
button.
The power switch is set to OFF.
Set the power switch to ON.
The supplied IR Remote
Commander does not
work.
Remote control operation is disabled. Enable remote control operation (page 32).
The battery of the IR Remote
Commander is exhausted.
Replace the battery with a new one.
Audio recording is not
possible.
The AUDIO LEVEL (CH-1/CH-2)
controls are set to the minimum level.
Adjust the audio recording levels with the AUDIO
LEVEL (CH-1/CH-2) controls (page 56).
The recorded sound is
distorted.
The audio level is too high.
Adjust the audio recording levels with the AUDIO
LEVEL (CH-1/CH-2) controls (page 56), and record
again.
The recorded sound has a
high noise level.
The audio level is too low.
Adjust the audio recording levels with the AUDIO
LEVEL (CH-1/CH-2) controls (page 56), and record
again.