Sony PMW-F3K - Manual (Page 113)

Setup Menu List 113
Me
n
u
C
o
nf
igur
at
io
n
a
nd Det
a
ile
d Set
tings
Horizontal Inv.
Setting the image
inversion function
On / Off Set to “On” to horizontally invert the image.
Lens IF
Selecting the lens
interface
Type C / Type A / Off Select the appropriate lens interface in advance before
attaching a lens.
Type C: For lenses with a Cooke-type connector and those
supplied with the PMW-F3K
Type A: For lenses with a ARRI-type connector
Off: For other lenses
CAMERA SET
Menu items Subitems and setting values Contents
AUDIO SET Menu
AUDIO SET
Menu items Subitems and setting values Contents
Audio Input
Setting for audio
inputs
TRIM CH-1
–20 dBu to –65 dBu (–41 dBu)
Finely adjust the sensitivity of channel 1 of microphone input
in steps of 3 dB in Manual audio adjustment mode.
TRIM CH-2
–20 dBu to –65 dBu (–41 dBu)
Finely adjust the sensitivity of channel 2 of microphone input
in steps of 3 dB in Manual audio adjustment mode.
Limiter
On / Off
Turn the audio limiter on/off.
MIC AGC
High / Low
Select the sensitivity of the microphone inputs.
AGC Link
Linked / Separated
Select the gain link condition when the audio level adjustment
is in AGC mode.
Linked: To vary the CH-1 gain and the CH-2 gain in
synchronization.
Separated: To vary the CH-1 gain and the CH-2 gain
independently according to the respective levels.
1KHz Tone
On / Off
Turn the 1-kHz reference tone signal on/off.
Wind Filter CH-1
On / Off
Turn the wind filter for channel 1 on/off.
Wind Filter CH-2
On / Off
Turn the wind filter for channel 2 on/off.
EXT CH Select
CH-1
CH-1/CH-2
CH-1: To record channel 1 audio input on both channels 1
and 2.
It is recommended to set the AUDIO SELECT (AUTO/
MANUAL) switch and AUDIO LEVEL control for CH-2
(page 56) as well as the above TRIM CH-2 to the same
conditions as those for CH-1.
CH-1/CH-2: To record channel 1 and channel 2 inputs on the
respective channels.