beautypg.com

On-screen error messages, Messages relating to dvd discs – Sharp DV-SR3U User Manual

Page 89

background image

89

On-screen Error Messages

Messages Relating to DVD Discs

• The following messages appear on the TV screen in case the disc you tried to play back is not appropriate or

the operation is not correct.

CANNOT PLAY BACK THIS DISC.

THIS IS A NON-STANDARD DISC.

REGION CODE OF DISC IS WRONG.

DISC NOT INSERTED.

CANNOT OPERATE THIS FUNCTION.

DISC IS PROTECTED.

COULD NOT REPAIR THE DISC.

COULD NOT FINALIZE.

THIS VIDEO IS COPY PROTECTED.
RECORDING IS NOT POSSIBLE.

CANNOT RECORD MORE.

CANNOT RECORD ON THIS DISC.

COULD NOT INITIALIZE.

DISC IS FULL.
CANNOT RECORD OR STORE.

CANNOT RECORD VIDEO TO THIS
DISC.

SET THE DATE AND TIME.

• The disc cannot be played with this

Recorder.

• If you load a disc which cannot be

played with this Recorder (i.e. a
scratched disc), or if you load a
disc upside down, this message will
appear, and the disc tray will
automatically pop out.

• Occurs if you load a DVD disc

whose region number is not “ALL”
or whose region number does not
contain “1”.

• Occurs if no disc is loaded in the

disc tray.

• Occurs if operation is incorrect.

• Occurs if you attempt to record or

edit a disc for which disc protection
is set.

• If there is a power failure during DVD

recording, the system automatically
tries to recover data after power is
restored. This error occurs if such
recovery is impossible.

• Occurs if the disc is scratched or

dirty, etc.

• Occurs if video with a copy guard

signal is input.

• Occurs if a title or chapter mark

exceeds the recordable upper limit.

• Number of titles: 99.

Number of chapters: 999

• Occurs if you load a disc which

cannot be recorded to with this
Recorder, or a disc which is
scratched or dirty.

• Occurs if the disc is scratched or

dirty, etc.

• Occurs if there is no empty space in

the disc.

• Occurs if you try to record a “Copy

Once” broadcast onto a disc which
is not compatible with CPRM.

• Occurs if timer programming is

done when the Recorder clock has
not been set.

• Check the disc, and load it

correctly.

• Cancel disc protection, or reload a

recordable disc.

• Check the disc, and load it

correctly.

• Cannot record.

• Erase unnecessary titles.
• Either erase unnecessary chapters,

or combine chapters.

• Reload an appropriate recording

disc.

• Check the disc, and load it correctly.

• Load a disc with empty space.
• Erase unnecessary titles.

• Load a CPRM compatible disc

(DVD-RW Ver. 1.1 or higher)
initialized in VR mode.

• Set the clock and perform timer

programming again.

Error message

Possible Error

Suggested Solution

Continued on Next Page

|||