Sharp DV-SR3U - Manual (Page 44)

44
Automatic Recording of Satellite Broadcast (AV AUTO REC)
VR MODE
DVD-RW
VIDEO MODE
DVD-RW DVD-R
When connected to a satellite receiver, etc.
with a timer recording function, this Recorder
can be used to automatically record the timer
program. (Refer to the operation manual of
the satellite receiver, etc. for instructions on
how to set the timer program.)
Example: Use of AV AUTO REC Function
Satellite
receiver, etc.
Set timer
program
2:00 AM 3:00 AM 4:00 AM 5:00 AM
2:00 AM 3:00 AM 4:00 AM 5:00 AM
Recording
begins
Recording
ends
Recording
begins
Recording
ends
Power OFF
Power
OFF
Timer
Program
Timer
Program
Power ON
Records
timer program
Records
timer program
Power ON
Set AV AUTO
REC function
This Recorder
Important!
• The AV AUTO REC function only operates
when used with a satellite receiver, etc.
with timer recording functions.
• The AV AUTO REC function will only
operate when the satellite receiver, etc. is
connected to the LINE IN 1 (AUTO REC)
jacks on the rear of the Recorder.
Connecting to a Satellite
Receiver, etc.
To use the AV AUTO REC function, connect
the satellite receiver, etc. to the LINE IN 1 (AV
AUTO REC) jacks on the rear of the Re-
corder.
COMPONENT OUT IN FROM ANTENNA
480i/
480p
OPTICAL COAXIAL
DIGITAL AUDIO OUT VHF/UHF/CATV LINE LINE S-VIDEO VIDEO R-AUDIO-L S-VIDEO VIDEO R-AUDIO-L PASS THROUGH
OUT 1
OUT 2
IN 1
AUTO
REC
IN 2
Satellite receiver, etc.
The Recorder
To LINE IN 1
(AV AUTO REC) jacks
Video/audio cable
(supplied)
To video/audio
output jacks
Recording with
AV AUTO REC
1
Set up the satellite receiver, etc.
• Set the recording timer on the satellite
receiver, etc. for the program you
wish to record. (Refer to the operation
manual of the satellite receiver, etc.
for instructions on how to set the
program timer.)
2
Turn off the satellite receiver, etc.
3
1 1 1 1 1 Press INPUT to select “L1”
(LINE IN 1 [AV AUTO REC]).
2 2 2 2 2 Press REC MODE to select
recording mode
• The recording mode will change as
follows each time you press REC
MODE.
• When selecting MNXX, the recording
mode will be set to the same as
selected in Manual Recording Mode.
4
Select external audio.
• Set “EXTERNAL AUDIO” of “REC.
FUNCTION” to “STEREO” or “DUAL
MONO” (page 76).
5
Press POWER to turn off the
Recorder.
6
Press and hold AV AUTO REC
(under the cover) for more than
two seconds.
• External automatic recording function
switches on or off every time you
operate this function.
• “AUTO REC” is displayed on the front
display panel (page 17).
• Recording automatically starts and
stops when the Recorder receives a
signal from satellite receiver, etc. at
start time and stop time.
FINE SP LP EP MN gg
NOTE
• When recording PPV (pay-per-view)
programs of satellite broadcasts, always
make sure to set the satellite receiver, etc.
to “Record”. Certain programs may not be
recorded or require additional charges for
recording.
• Use AV AUTO REC in combination with a
satellite receiver, etc. equipped with a timer
recording function.
• Since the power of this Recorder is
switched on after the video signal from a
satellite receiver, etc. has been received,
the start of a program may not be re-
corded.
• When using AV AUTO REC function, it is
recommended that you set the timer
recording start time for a satellite receiver
etc. a little earlier than usual.