Speco Technologies DVR-PC8 Series - Manual (Page 61)

61
6.7 FPS/Resolution
Adjust the frame for each channel of the DVR with this menu. (On the DVR-PC8/16 Series, recording frame setting can
be adjusted but it does not support resolution setting per camera.)
6.7.1. FPS and Resolution Setting per Camera
To use this setting, the recording should be stopped.
FPS Setting per Camera
The setting cannot be higher than the total recording frame setting value of
the all the cameras.
Ex) In case the model used is of 240fps and 1~8 channels are set as 20fps
each, the total setting value for 9~16 channels cannot be over than
240-(20X8)=80fps.
6.7.2. System Recording Performance
Move the slide bar of each camera to set the frames. The maximum recording
frame rate per camera is 30fps. In case the frames do not go up after certain
value; it means the maximum frame has already been exceeded. The
maximum frames of the system differ according to the selected recording
mode. (Refer to Recording Setting)
6.7.3. Display Max
This feature allows the system to maintain to the speed for monitoring possible
to capture in DVR-PC8/16 series, which the Recording speed and monitoring
speed are same. User can view the best quality image when this feature is
selected since the recording speed is set low even though monitoring speed is
supported to max.
For example, in case of using DVR-PC8/16, monitoring speed is maintained to
max frame not depending on the recording setting frame number in regards to
max frame by each display resolutions. Even though recording speed by
channel is set as 1 frame in 320x240, monitoring speed will be max speed of
120fps when [Display MAX] is selected. This feature is can be used in setting
method of frame number by channel