Sun Microsystems StorageTek HP LTO4 - Manual (Page 30)

Using VOP
22 KMS: LTO4 Technical Brief • June 2008 Revision: A • 316196601
During the commit process, the tape drive goes offline then IPLs to save the new
settings to the Dione card.
Important:
When the drive comes back online, it is now using the new IP address.
8. To continue with the configuration and to “enroll” the tape drive, you must
connect the drive to the KMS network. The KMS must be able to communicate
with the tape drive to complete the enrollment process.
Note – The Agent must be already created with a pass phrase assigned in the
KMS before you can enroll the drive. If you were to “Unenroll” the Agent—for
example: To turn encryption off, then re-enroll the agent to turn encryption back
on—the pass phrase must be re-entered or the agent recreated in the KMS before
re-enrollment.
9. Enter the new IP address in the connection window and click Connect
(10.0.0.5 for this example).
10. Select the Configure Drive tab. The new settings are shown in the display.
11. Click “Enroll.”
12. Click on the Diagnose Drive tab to observe the enroll process.
■ The enroll process takes about 40 seconds to complete.
■ When the enrollment is complete, the button now indicates Unenroll.
■ You would use this button to unenroll the tape drive; which would turn
encryption off (see the note in Step 8).
FIGURE 3-6
10.0.0.5
10.0.0.5