Siemens C79000 Z7076 C638 04 User Manual
Page 66
Error Diagnosis and Reinstallation
6-16
SIMATIC Box PC 620 Operating Manual
C79000-Z7076-C638-04
4. When “Microsoft Windows 98-Startup Menu” is displayed, select
“1. Boot for CD-Recovery”.
5. You have to acknowledge the “SIEMENS End User License Agreement” with
the F8 function key. Pressing ESC allows you to decline the agreement and
cancels the installation.
6. In the next screens you can select the components which are to be copied from
the CD to the hard disk. Transfer of at least the folder “I386” is necessary for
the Windows NT installation or setup.
7. Select the drive for data transfer. You can use the selected drive as the installa-
tion drive for Windows. For the Windows setup, you need an available disk
space of approximately 300 MB on the installation drive for Windows.
Note
By default, drive C: is used for the data transfer (Recovery).
Ensure that there is an available disk space of approximately 300 MB left on drive
C: after the selected recovery data have been copied.
8. Confirm the end massage box.
9. Start the Windows setup program
LW:\I386\Winnt.exe b/
LW is the drive where the recovery data have been copied.
You can find the information on installation of Windows NT on the Recovery CD in
the folder SUPPORT\BOOKS\.
Note
If you want to become an expert user of Microsoft Windows NT Workstation, see
the “Windows NT Workstation Resource Kit” Version 4.0 (is not included in the
package). It contains specific information for administrators who are responsible
for installing, managing, and integrating Windows NT Workstation in a network or
multiuser environment.
6.10.2
Installing the Microsoft Windows 98 Operating System
You should only follow these steps when you wish to upgrade from Windows NT to
Windows 98 or install Windows 98.
1. Insert the CD-ROM Microsoft Windows 98 in the CD-ROM drive and switch on
the PLC.
2. To boot from the Windows 98 CD proceed as follows: When the message
Press
appears on the screen press the ESC key. After intialization a boot menu to select
the boot options is displayed.
3. Select “ATAPI CD-ROM Drive”.