Siemens C79000 Z7076 C638 04 User Manual

Page 2

Safety Guidelines

This operating manual contains notices which you should observe to ensure your own personal safety, as
well as to protect the product and connected equipment. These notices are highlighted in the manual by a
warning triangle and are marked as follows according to the level of danger:

Warning

indicates that death, severe personal injury or substantial property damage can result if proper precautions
are not taken.

Danger

indicates that minor personal injury or property damage can result if proper precautions are not taken.

Note

draws your attention to particularly important information on the product, handling the product, or to a
particular part of the documentation.

Correct Usage

Please observe the following

Note

You can set up and operate your programming device in conjunction with the following instructions. You
should only connect external devices and work with memory cards in conjunction with the manual SIMATIC
Box PC620. The manual is also available in electronic form on the CD-ROM labeled ”Documentation and
Drivers”.

Only qualified personnel should be allowed to install and work on this equipment using the manual.
Qualified persons are defined as persons who are authorized to commission, to ground, and to tag
equipment, systems, and circuits in accordance with established safety practices and standards.

Warning

This device may only be used for the applications described in the catalog or manual, and only in connec-
tion with devices or components from other manufacturers which have been approved or recommended
by Siemens.

This product can only function correctly and safely if it is transported, stored and set up carefully and
correctly, and operated and maintained as recommended.

Trademarks

SIMATIC

R ,

SIMATIC NET

and SIMATIC HMI

are registered trademarks of Siemens AG.

The transmission and reproduction of this documentation and the

exploitation and communication of its contents are not allowed, unless

expressly granted. Contraventions are liable to compensation for

patent or registration by GM.

We have checked the content of this publication for compliance with the

described hardĆ and software. However, discrepancies cannot be excluĆ

ded, with the result that we assume no guarantee for total compliance. The

information in this publication is checked regularly, and any necessary

corrections are included in the following editions. We would be grateful for

any suggestions for improvement.

Siemens AG 2000

Subject to technical change.

Exclusion of Liability

Copyright

Siemens AG
Bereich Automatisierungs- und Antriebstechnik
Geschaeftsgebiet Industrie-Automatisierungssysteme
Postfach 4848, D-90327 Nuernberg

C79000ĆZ7076ĆC638

Siemens Aktiengesellschaft