Siemens C79000 Z7076 C638 04 - Manual (Page 55)

Error Diagnosis and Reinstallation
6-5
SIMATIC Box PC 620 Operating Manual
C79000-Z7076-C638-04
6.5 The Clock Time and/or the Date in Your PC Is Incorrect
Remedy
Set the clock time and the date in the setup menu.
Press to call setup when booting the computer.
Note
The battery is dead if the clock time and the date are still incorrect after you switch
off your PC and switch it back on again. In this case, please contact your technical
support team (Chapter 8).
6.6 An Error Message Appears on the Screen
Error Messages
The following table describes the error messages that the BIOS system outputs.
Error messages the operating system or program outputs are described in the
manuals for these programs.
Press to call Setup when booting the computer.
Error Message on the Screen Meaning/Suggestion
Address conflict Plug and Play Problem
Contact your technical support team.
Combination not supported Plug and Play Problem
Contact your technical support team
IO device IRQ conflict Plug and Play Problem
Contact your technical support team
Invalid System Configuration
Data Plug and Play Problem
Please set the option RESET CONFIGURATION.DATA in the
Advanced Setup menu.
Contact your technical support team
Allocation Error for ... Plug and Play Problem
Please undo the last hardware change.
Contact your technical support team
System battery is dead
Replace and run SETUP The battery on the CPU module is defective or dead.
Contact your technical support team
System CMOS checksum bad
Run SETUP Call up SETUP, adjust settings and save. If this message appears
during each power up, contact your technical support team.
Incorrect Drive A type
Run SETUP Check the SETUP entries for drive A.