Siemens C79000 Z7076 C638 04 - Manual (Page 65)

Error Diagnosis and Reinstallation
6-15
SIMATIC Box PC 620 Operating Manual
C79000-Z7076-C638-04
6.10 Installation of the Windows Operating System
Dependent on the device model, different operating system CDs are shipped:
Microsoft Windows NT or Recovery Microsoft Windows NT,
Microsoft Windows 98 SE or Recovery Microsoft Windows 98 SE,
Recovery Microsoft Windows 2000.
6.10.1 Installing the Microsoft Windows NT Operating System
Install the operating system directly from the operating system CD supplied.
Proceed as follows:
1. Insert the CD.
2. Reboot the system hold the ESC key down.
The boot menu appears on the monitor.
3. Select ”ATAPI CD-ROM Drive”.
Windows will be installed from the CD.
4. Follow the installation program instructions on the screen.
Installation of the Recovery CD in Microsoft Windows NT
This CD contains encoded data which can only be transferred onto a SIEMENS
SIMATIC PC.
Data transfer is carried out with the OEMSETUP.EXE program on the CD-ROM or,
after booting, from the CD-ROM with the Recovery function.
After transferring the required data to the hard disk, the operating system can be
installed using the Windows NT setup program.
Windows NT Installation Sequence
If a Windows operating system is already installed or if the PC has been started
with a user created bootdisk, the transfer of the data takes place using the
program OEMSETUP.EXE. To do this, start the program OEMSETUP.EXE on the
recovery CD and continue the sequence as of point 5.
If there is no operating system installed, then please do the following:
1. Insert the Recovery CD and reboot the system.
2. To boot from the CD proceed as follows: When the message
Press to enter Setup
appears on the screen press the ESC key. After intialization a boot menu to select
the boot options is displayed.
3. Select ”ATAPI CD-ROM Drive”.