Sundance Spas 680 - Manual (Page 34)

Page 28
680 SERIES
10.5 Selecting The Filtration/Heating Mode
Press and hold both control panel WARMER ( ) and
COOLER ( ) buttons at the same time, then release.
Then press either WARMER ( ) or COOLER ( ) button to select
filtration/heating mode F1-F6 or lock modes L1-L2 on the following
pages.
10.6 Filtration Modes for Spas Without Circulation Pump Option
If your spa is equipped with the circulation pump option, disregard this
section and refer to page 29 for filter cycle programming details.
Standard Filtration/Heating Modes (F1-F3)
F1 4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F2 6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F3 8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Economy Filtration/Heating Modes (F4-F6)
F4 4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F5 6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F6 8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit filter
cleaning).
L2 Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa). Filtration/heating cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is enable.
Example: the “F3” filtration/heating cycle was enabled prior to
choosing lock mode. The spa continues to perform the “F3” cycle
until lock mode is canceled, allowing another cycle to be selected.
Filter Cycle Setup Example
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
first filtration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM.
Note: Start time is approximate and may vary slightly from day to day.