Sundance Spas 680 - Manual (Page 25)

Page 19
680 SERIES
10. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting plastic
knobs and pillows on Burlington, Hartford, Hawthorne
and Tacoma models from chemical attack. If spa is
indoors, open doors and windows for proper ventilation.
Turn on all spa jets pumps for one hour, open all air
controls. On Burlington, Hartford and Hawthorne (Figure
A) and Denali (Figure B) models, place the Massage
Selector or Diverter Jet in their center “combo” position
as shown (right).
Note: You will need to press the jets pump button(s) every 20
minutes since these functions have an automatic 20 minute
time-out function that turns them off.
CAUTION: Never leave your spa unattended for any reason
while the cover is open and accessible to small children and
animals!
!
11. Turn off power to the spa at the circuit breaker, then drain spa as
outlined in Section 11.2 (page 31).
12. Refill spa with clean tap water from garden hose until water covers
all jets (DO NOT OVERFILL!)
CAUTION: Never fill with water from a water softener. If your
water is extremely “hard”, it is preferable to fill half-way with
hard water and the rest of the way with softened water. Or,
you may fill entirely with hard water if you use a special water
additive available from your authorized Sundance dealer.
!
13. Consult your authorized Sundance dealer for chemical
recommendations, then add chemicals to spa water to achieve a
constant sanitizer reading within the levels recommended by the
Association of Pool And Spa Professionals/USA printed on the inside
cover of this manual.
14. Turn on all jet pumps when adding chemicals to ensure proper
mixing and leave your spa cover open until the sanitizer level falls
below 4.0 ppm to protect plastic knobs and pillows from chemical
attack.
Set all air controls
to their full open
counterclockwise
position
Figure B
Figure A
B
Massage Selector