Siemens CCMX1315-LP - Manual (Page 7)

Safety
7
Siemens Building Technologies
Fire Safety & Security Products 01.2009
Damage due to unsuitable mounting location
z The environmental conditions recommended by the manufacturer must be
observed. See Section 3: Specifications.
z Do not operate the device in dusty places.
z Do not expose the device to mechanical vibrations or shocks.
z Protect the device against moisture.
z Place the unit on a stable surface that will hold its weight.
z The mounting surface must be solid and non-combustible.
z Do not operate the device close to sources of powerful electromagnetic
radiation.
Danger of electrical shock due to incorrect connection
z Connect the device only to power sources with the specified voltage. Voltage
supply requirements can be found on the mains adapter.
z Make sure the device is permanently connected to the electricity supply; a
readily accessible disconnect device must be provided.
z This device is designed to work with 12 V DC / 24 V AC-systems or PoE. Do not
connect the device to any other power systems.
1.2.3 Cleaning
Do not touch the imaging surface of sensor. Use a soft cloth moistened with
alcohol to clean the surface if it is touched accidentally.
1.3 Meaning of the signal words
The severity of a hazard is indicated by the following written signal words.
Signal word Type of risk
DANGER Imminent danger of death or severe bodily injury
WARNING Possible danger of death or severe bodily harm
CAUTION There is a risk of minor to medium injuries or damage to property.
IMPORTANT Malfunctioning may result
1.4 Meaning of the hazard symbols
The nature of the hazard is indicated by icons.
Warning of a hazard
Warning of dangerous electrical voltage
Tips and information