Japan Tiger 7100e+ - Manual (Page 145)

User Manual 145
English
Troubleshooting
This chapter describes typical problems when using the Fast
EtherNet and tips for solving them.
Problems during the self-diagnosis test and
while printing the configuration contents
Printer does not print
· Check that DIP switch [3] (Configuration report) and [4]
(Self-diagnosis test) of the Fast EtherNet are on. Turn the
printer off before changing the DIP switch.
· If the printer is on, turn the printer off and then on again.
· Ensure the printer emulation is set to “PCL” or “Automatic”.
NG is printed in the self-diagnosis test
If the ROM Check and RAM Check are NG
· Confirm that the Fast EtherNet is installed properly, then
turn the printer off and then on again.
If the EEPROM Check is NG
· Confirm that the Fast EtherNet is installed properly, then
turn the printer off and then on again.
· Turn the printer off, switch DIP switch [2] on and turn the
printer on again. This will initialize the Fast EtherNet.
If the NIC Check is NG
· Confirm that the Fast EtherNet is installed properly, then
turn the printer off and then on again.
· Confirm that the network cable is correctly connected. If
possible, connect to the network of a different segment.
A Network Format Different Than the Format of the Network
Connected is Printed
· Confirm that the network cable is installed, then turn the
printer of and then on again.
· Change the network cable, then turn the printer off and
then on again.
7100e+.p65 25/08/99, 20:55 PM 145